Hi,
I am looking for PC10 dual monitor parts such as:
Control Panel
Marquee
Monitor - Sanyo 20EZ
Wiring Harness
Thanks !
WTB: Playchoice 10 parts
Moderators: Sparky, maxlords, machine.slave, Doc Kaos, mark, omnedon
Re: WTB: Playchoice 10 parts
Where are you located? Are you looking for 20ez chassis or complete monitor
-
- Posts: 7
- Joined: Tue Feb 14, 2017 4:00 pm
Re: WTB: Playchoice 10 parts
I am near Montreal, Quebec. I am looking mainly for the tube. I have a functional monitor but with severe burn and low brightness. I tested the tube with a crt tester and it definitely is dying.
Re: WTB: Playchoice 10 parts
That suck. Those tube are getting harder to come by.
Re: WTB: Playchoice 10 parts
Have you ever done a Tube swap, there lots of TVs that used the same tubes as monitor`s from 80 90`s... i did a swap on my Nintendo monitor EZ20 ( a
Goldstar 1991 19 inch tube)... there a lot of 19 inch tubes are CR-23 Socket and same pin-out , just got to find one with the same yoke same or close OHM reading ,,their a great cross reference chart people have been adding to
http://junknet.net/donor-tvs
Goldstar 1991 19 inch tube)... there a lot of 19 inch tubes are CR-23 Socket and same pin-out , just got to find one with the same yoke same or close OHM reading ,,their a great cross reference chart people have been adding to
http://junknet.net/donor-tvs
Re: WTB: Playchoice 10 parts
this another trick that not 100% fool prof but it works for the poor man How to convert a 56 ohm vertical yoke to 15 ohms
Who is online
Users browsing this forum: No registered users and 13 guests